Lomart pool installation part needed

Notice the close up view of me adjusting the rail gap at the bottom connector. Make any needed adjustment over several different connectors in order to keep the rail gap uniform. Only when the wall is bolted together and secure with rods or pool frame do I start spreading the sand. I start at the outer edge with 6" cove and then a uniform 2" over the rest. I then smooth the entire area with the flat side of my rake and follow that with a large broom.

Once the sand is completely smooth I will not be back in the pool again. The pool will be completely full and the sand well packed before anyone is inside. From the outside of the pool we drape the liner over the wall. If we have used the pool framework for structure we use plenty of duck tape to cover any sharp edges.

Using the interlocking rods, as in this case, we hold them in place with tape. Also tape the nuts and bolts on the outside of the wall to prevent tearing the liner. The liner is pulled over the wall until the bottom is laying smoothly on the inside. This method will keep all the wrinkles out of the pool. As the pool fills we lower the liner until the water is out to the edge of the pool. At this point turn the water off and put the liner in place.

It would be hard to find a better value on the internet. The quality is there and the prices are the best you will find. The 25 year warranty, or the thirty year, make them everything you could want in an above ground pool.

I recently found this Lomart pool on Amazon in the 16' round and 12' round sizes. Lomart Above Ground Pool ad. Thanks Pv2. That was my understanding as well. Replacement parts are on the way and I'm going to change how the pool gets it's chlorine, so we'll see how it goes.

You must log in or register to reply here. Thread Status. Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread. Similar threads K. Lomart Montessa vs Verona. Replies 2 Views Started my 18x16 deck. Have a few questions. Lph Jun 18, Above Ground Pools. Replies 4 Views Above Ground Pools Jun 19, Lph Replacing the corner rails on an Intex Ultra 16x Above Ground Pools Jun 16, zea3.

AGP center cap removal help! Brandon Mar 16, Above Ground Pools. Above Ground Pools Mar 25, kimkats. Above Ground Pools Jul 8, crokett.